Moonshine Still – Low Temp Vacuum Thumper Assembly

Drill thumper & collector lids using high speed drill with sharp bit. Bit slightly larger than the adapter COMP threads. Then file and hammer flatten lids. Place O-rings on COMP threads & thread and thru the LID top. Tighten the compression nut to the lid bottom to seal O-ring against lid top.

Find a bit slightly larger than pipe but smaller than the inside of the adapters. Drill out all the way through male & female adapters for thumper inlet only(1)

Notch end of thumper pipe, file pipe end smooth to ease pushing through both adapters & into jar.
Apply Teflon tape to all MIPs and tighten female adapter FIP the the MIP for three jar connections.

Tighten all connections and assemble thumper. Fill thumper 1/2 full with your undistilled fluids.

 

Only operate any still outdoors. Obtain all required building, safety, federal and state permits and licenses before operating your still.